The Link-Belt® Sure Align Tracker by Conveyors Plus is a belt conveyor alignment system for the mining, oil, gas, and material handling sectors. It is an affordable and proven system that immediately increases safety, productivity, and cost savings. Since its inception in 2004, the Sure Align Tracker has experienced widespread acceptance of this innovative and highly successful alignment system in major mines worldwide. Systems are currently installed with Newmont, FMI, Xstrata, BHP, Lafarge, Barrick, Rio Tinto, Vale, Goldcorp, Detour, Codelco, IOC, Brigus Gold, DeBeers Diamond Mines, Coal mines, CNRL Oil Sands and Potash Corporation.

The belt trackers are used on belt widths from 12 to 160 inches. The rollers are manufactured with half-inch rubber lagging, and the return trackers are installed on the clean side of the belt. The trackers are proven effective on belts ranging from slow-speed feeder belts (less than 0.1MPS or 0.3FPS) to high-speed belts (up to 7MPS or 23 FPS).

Syntron® MF heavy-duty electromechanical feeders are the heavyweights of bulk material handling, used for higher-capacity requirements. The eight heavy-duty models handle capacities from 100 to 4,000 tons per hour.*

Syntron heavy-duty electromechanical feeders combine extra structural strength with durable components. The deep wing plates form a bridge between the inlet and discharge suspension supports, providing extra strength for years of dependable service. Standard troughs feature unitized weldments—one-piece, completely welded units for greater strength. Troughs are also available with bolt-together construction for tunnel installations or other confined areas. MF heavy-duty electromechanical feeders are two-mass, spring-connected, and sub-resonant-tuned. The exciter unit is connected to the trough via corrosion-resistant polymeric drive springs, which reduce vertical stroke while amplifying stroke in the direction of material flow. This feature creates straight line motion, providing maximum material flow rate and feeder capacity. Syntron feeders also utilize custom-engineered electromechanical vibrators. These vibrators feature an L10 life expectancy of over 100,000 hours in normal operation, and they allow quick removal via access from both sides of the feeder or from the bottom. Attachments for safety cables are included on all Syntron feeders.

*Based on dry sand weighing 100 pounds per cubic foot. Capacities vary depending on material characteristics, material density, trough length and width, trough liner type, feeder installation, skirt boards, and hopper transitions.

The SyntroFlo cone crusher loading feeder by Syntron is a MF two-mass tuned direct drive vibratory feeder with an engineered discharge uniquely designed for equal distribution of product. The trough including the discharge is fully lined to account for wear. Like traditionally designed feeders, it is suspension mounted, which can be easily integrated into a trolley system allowing it to be moved out of the way for crusher maintenance. In side-by-side installations of a feeder-plus-rotary distributor versus a SyntroFlo cone crusher loading feeder directly feeding the crusher, the SyntroFlo unit delivered superior, cone-friendly performance. The uniform distribution provided by the SyntroFlo unit increased curser manganese life and yielded more cubicle-formed product.

SyntroFlo is available in three standard sizes for tertiary crusher applications: STF-3F, STF-4F, and STF-5F. In addition, we are developing the STF-3C, STF-4C, and STF-5C for secondary crushing applications. Both designs work with 300 HP, 400 HP, and 500 HP cones, respectively. These designs will allow the SyntroFlo unit to be a cost-effective solution for feeding your cone crusher equipment. We can build a custom cone crushing feeder unit for larger and smaller applications upon request.